It’s a typical state of affairs you’re sitting down stairs watching the TV or studying a e-book, and you then hear a loud bag from upstairs. Let it dry, then apply extra drywall compound, feathering the perimeters as you go. Like we did for the patches we mentioned earlier, it is going to take several coats, in addition to a lightweight sanding, between each coat. Photograph four: Apply a second coat of compound, drawing it at the least 6 in. past the edge of the first coat to taper the sides of the repair.
For holes bigger than 6 inches, you’ll create a drywall patch with a distinct attachment method for the repair. After the compound dries, add a second skinny coat of compound over the taped space. Picture 5: Sand the dry compound lightly with one hundred-grit sandpaper to take away ridges and blend edges.
Photo three: Fill the holes with joint compound, swiping first across the holes, then down. To repair a gap in your wall typically requires some sort of patch to cover the outlet, whether it is a steel patch just like the one I am holding here, or one other piece of drywall like this.
Minimize along the lines on the wall with a drywall knife. Cut a bit of drywall right into a square shape that’s 2 inches bigger in width and height than the realm to be repaired. All you need to do now’s prime the patch utilizing a drywall primer then paint the patch to match the present wall shade.
Drywall harm that extends throughout a number of wall studs requires extra intensive reinforcement and repair. They require only primary tools and a few drywall joint compound Also be prepared to touch up or paint the repaired area. It’s simpler so as to add backer board than to attempt to cut the drywall over studs (Photograph 2). Minimize the backer boards about 4 in. longer than the height of the opening.